Plastic Shim Strips
Dayton Superior P-80 Shim Strips assure accurate placing and leveling of tilt-up panels and other architectural and structural components because they are made in convenient thicknesses, lengths and widths allowing precise leveling and alignment.
• permit field changes in load bearing requirements with stock on hand.
• are less expensive and safer than steel. They have extreme stability and eliminate rust-stained concrete and spalling.
• are size scored for convenience of application. Prevent waste – material can be readily picked up and stored in the open for future use.
• will not fracture under load.
• are available from stock in thicknesses of 1/16", 1/8" and 1/4" and lengths of 3" and 4". The widths of 3" x 24" are scored every 3" and the widths of 4" x 24" are scored every 2". This allows for easy snap off as needed. Additional sizes available on request.
• are impervious to liquids, ground chemicals, alkalis and microorganisms. The continuing performance characteristics are stable and predictable.
• will not rust, rot or leach when exposed to wet surfaces and have no odor.
• arrive at the job site in precise thicknesses and lengths.• eliminate the need for saws, hand tools or cutters. A definite saving in time, labor and money is realized. The strips are easily applied and lie flat.
• decrease damage potential to the adjacent concrete components. Point projection of aggregate is absorbed without fracture or effect on the load-bearing characteristics. Engineering Data: The pertinent physical properties of Dayton Superior plastic shims are presented as follows:
• Compressive strength of 8,000 to 9,000 psi with no fracture, even at 26,000 psi.
• Classed as slow-burning with no toxic fumes.• Negligible cold flow characteristics; i.e., less than 1% at 1,000 psi and 73° F. for 10,000 hours.
• Coefficient of linear expansion is 3 to 5 x 10-5 inches/inch/°C.
-
SP ¼ X 3 X 4
-
SP 1/8 X 3 X 4
Vendors: Dayton Superior, Meadow Burke, Universal Form Clamp
